---

faydası olması dileği ile.

obs

---

---

saol kardeş çok işime yarıyacak ...!

---

Başa dön

---

RAR içeriğinden bahseder misin biraz?

---

Başa dön

---

malzeme yerleşimi + pcb + devre şeması + hex kodu olması lazım

obs

---

Başa dön

---

kumanda

arkadaşlar uzaktan kumandayı devreye nasıl tanıtıyoruz yani hangi tuş lambayı karartıp açıp kapatıyor bileniniz var mı acaba yardımcı olursanız sevinirim iyi günler....

---

Başa dön

---

Merhaba obs bu devreyi denedin mi?

---

Başa dön

---

evet..güzel bir uygulama..uzaktan kontrol..emeğine sağlık

---

Başa dön

---

ingilizce olarak söyle yazıyor ayrıca RC5 sistem uyumlu uzaktan kumanda kullanın diyor.
obs

(Re)adjust the dim-levels:
(only necessary when changing the maximum-, minimum- or start-up- level)
First you should select an unused system on your remote control, i.e. SAT, AMP, VCR2 or DCC mode.

Adjust maximum level: Keep, while switching the power on, the P+ button from the remote control pressed and wait until the lamp burns on desired maximum level.

Adjust minimum level: Keep, while switching the power on, the P- button from the remote control pressed and wait until the lamp burns on desired minimum level. Recommended is to adjust the minimum dim level not to "lamp off" level, because then it's easy to forget to switch the power off and use unnecessary power.

Adjust start-up level: Keep, while switching the power on, the '0' button from your remote control pressed and wait until the lamp burns on desired level.

Re-adjust the default values (reset): Keep, while switching the power on, the MUTE button from the remote control pressed.

During adjusting the dim-levels, the dim-level changes slower then normal to make adjusting easier.
When letting the button loose and the adjustment is ok, the red- en green LED blinks for a while.
With the -for the dimmer reserved- system selected on the remote control, the P+ (dim-level up) / P- (dim-level down) and button '0' (up/down turn by turn) works too.
Button '1' dims directly to the adjusted start-up level.
Which system on the remote control is choosen doesn't matter, the '0' button works always in the TV-mode too.

Above described applies to the here downloadable .BAS and .HEX examples, but you can ofcourse modify it to your own wishes.
Keep in mind that a remote control does not always send that what you expected.
The volume from TV, SAT, VCR1 and VCR2 are all the same.
Just as the volumegroup from TAPE, TUNER, CD, etc.
And the '0'-'9' buttons from system TAPE for example send nothing at all.

---

Başa dön