usb ses kartı (pcm2702)

ta2mc · Tarih: 24.04.2008, 01:16 Mesaj konusu: **usb ses kartı (pcm2702)**

Denemediğim, fakat faydalı olabileceğini düşündüğüm bir devreyi sunuyorum.

Gerekli bütün dosyalar ektedir. Ayrıca, puanı yeterli olmayan üyeler alıntı yaptığımten tüm detaylara ulaşabilirler.

http://www.electronics-lab.com/projects...index.html

Alıntı: USB Sound Card with PCM2702
author: diy4fun.blogspot.com / Miroslav Batek

Make a sound card is no more a complex issue. If you use great IC PCM2702 from BURR BROWN / Texas Instruments you can create a fully functional USB sound card. This sound card can be powered from USB port and has one stereo output. You don�t need to install any driver for Windows XP and Vista, because they are already inside. This is really plug and play.

Few months ago I have seen USB sound card called Alien DAC. The construction on the project web page inspired me to build this thing also.

Description

The core of this construction is 16-Bit Stereo Digital-To-Analog Convertor with USB interface PCM2702.

PCM2702 needs only few additional parts to work. The schematic is not complex. Sound card can be powered directly from USB port (jumper W1) or from external power supply (jumper W3). PCM2702 needs two power supply 3.3V (3V-3.6V) and 5V (4.5V-5.5V). I used fixed output voltage LDO TPS76733Q for 3.3V (IO2) and adjustable output voltage LDO TPS76701Q for 5V (IO3). Both LDO are produced by TI, I used this because I had it in my drawer. Any similar LDO can be used. Output voltage of IO3 should be set to little bit lower than input voltage to allow LDO good stabilization, in my case output voltage is set to 4.8V. Output voltage can be set by adjustable resistor R33. In case of low power supply, IO3 can be shorted by jumper W3. LED D3 signalizes power on.

Assembled top side

Small ferrite beads are placed before all power pins of PCM2702 and in Vbus and GND of USB. These small beads reduce high frequency hum. I had a problem find this small SMD ferrite beads in local stores but finally I acquire few of them from old hard drive. They are not absolutely necessary, you can use zero ohm resistors instead of them.

Low-pass filter is placed in output signal path to reduce sampling frequency. An OPA2353UA dual op amp is configured as a stereo 2nd-order low-pass filter. Led diode D1 is illuminated when PCM2702 plays audio data received from the USB bus. Led diode D2 is illuminated when USB bus suspends audio data transmission to the PCM2702.

Schematic

Schematic of sound card with PCM2702

PCB

PCB assembly diagram

Assembled bottom side

Tüm dosya ve detaylara aşağıdakiten ulaşabilirsiniz.
http://www.electronics-lab.com/projects...index.html

TFN · Tarih: 24.04.2008, 17:53 Mesaj konusu:

Entegreleri bulmak biraz zor gibi (: